Digi TX54 User Manual page 930

Monitoring
12. Confirm that users who will use the Wi-Fi scanner server are members of an authentication
group that has Wi-Fi scanner access enabled. See
authentication group configuration information.
13. Click Apply to save the configuration and apply the change.

Command line
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Enable the Wi-Fi scanner:
(config> monitoring wifi_scanner enable true
(config)>
4. Set the appropriate Wi-Fi radio (dual Wi-Fi models only):
(config)> monitoring wifi_scanner radio value
(config)>
where value is either wifi1 or wifi2.
5. (Optional) Set the Wi-Fi channels that will be scanned by this instance of the service:
(config)> monitoring wifi_scanner channels value
(config)>
where value is a comma-separated list of channel numbers, or all to scan all channels. The
default is all.
6. (Optional) Set the frequency, in milliseconds, that the Wi-Fi scanner will hop from one channel
to the next during scanning:
(config)> monitoring wifi_scanner hop_frequency value
The default is 150.
7. (Optional) Set the number of seconds between scans.
(config)> monitoring wifi_scanner update_interval value
TX54 User Guide
iii. For Zone, select the appropriate firewall zone from the dropdown.
See Firewall configuration
iv. Click  again to allow access through additional firewall zones.
for information about firewall zones.
Add an authentication group
Enable the Wi-Fi scanner
for
930