Table of Contents
Advertisement
Services
[
4]
8.00-9.00
[
4]
9.00-10.00
- - - - - - - - - - - - - - - - - - - - - - - - -
[ ID] Interval
[
4]
0.00-10.00
[
4]
0.00-10.00
iperf Done.
$
Configure the ping responder service
Your TX54 device's ping responder service replies to ICMP and ICMPv6 echo requests. The service is
enabled by default. You can disable the service, or you can configure the service to use an access
control list to limit the service to specified IP address, interfaces, and/or zones.
To enable the iPerf3 server:
WebUI
1. Log into the TX54 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Services > Ping responder.
The ping responder service is enabled by default. Click Enable to disable all ping responses.
4. Click to expand Access control list to restrict ping responses to specified IP address,
interfaces, and/or zones:
To limit access to specified IPv4 addresses and networks:
n
a. Click IPv4 Addresses.
b. For Add Address, click .
c. For Address, enter the IPv4 address or network that can access the device's ping
TX54 User Guide
sec
33.5 MBytes
sec
33.2 MBytes
Transfer
sec
315 MBytes
sec
313 MBytes
responder. Allowed values are:
Configure the ping responder service
281 Mbits/sec
0
279 Mbits/sec
0
Bandwidth
Retr
264 Mbits/sec
37
262 Mbits/sec
1.60 MBytes
1.60 MBytes
sender
receiver
662
Advertisement
Table of Contents
