Digi TX54 User Manual page 126

Interfaces
IPv6 configuration:
n
The metric for IPv6 routes associated with the WAN.
l
The relative weight for IPv6 routes associated with the WAN.
l
The IPv6 management priority of the WAN. The active interface with the highest
l
management priority will have its address reported as the preferred contact address for
central management and direct device access.
The IPv6 Maximum Transmission Unit (MTU) of the WAN.
l
When to use DNS: always, never, or only when this interface is the primary default route.
l
SureLink active recovery configuration. See
l
WAN/WWAN failures

WebUI
1. Log into the TX54 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Network > Interfaces.
4. Create the WWAN or select an existing WWAN:
To create a new WWAN, for Add interface, type a name for the WWAN and click .
n
To edit an existing WWAN, click to expand the WWAN.
n
New WWANs are enabled by default. To disable, click Enable.
TX54 User Guide
Configure SureLink active recovery to detect
for further information.
Wide Area Networks (WANs)
126