Table of Contents
Advertisement
Firewall
3. Click Firewall > Port forwarding.
4. Click the menu icon (...) next to the appropriate port forwarding rule and select Delete.
5. Click Apply to save the configuration and apply the change.
Command line
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Determine the index number of the port forwarding rule you want to delete:
(config)> show firewall dnat
0
acl
enable true
interface eth2
ip_version ipv4
label IPv4 port forwarding rule
port 10000
protocol tcp
to_address6 10.10.10.10
TX54 User Guide
no address
no zone
Port forwarding rules
803
Advertisement
Table of Contents
