Routing Services - Digi IX14 User Manual

Routing
b. Set the interface. For example:
address: Matches the destination IPv4 address to the specified IP address or network.
n
Set the address that will be matched:
(config network route policy 0)> dst address value
(config network route policy 0)>
where value uses the format IPv4_address[/netmask], or any to match any IPv4
address.
address6: Matches the destination IPv6 address to the specified IP address or network.
n
Set the address that will be matched:
(config network route policy 0)> dst address6 value
(config network route policy 0)>
where value uses the format IPv6_address[/prefix_length], or any to match any IPv6
address.
mac: Matches the destination MAC address to the specified MAC address. Set the MAC
n
address to be matched:
(config network route policy 0)> dst mac MAC_address
(config network route policy 0)>
11. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
12. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Routing services

Your IX14 includes support for dynamic routing services and protocols. The following routing services
are supported:
IX14 User Guide
/network/interface/modem
Current value:
(config network route policy 0)> dst interface
(config network route policy 0)> dst interface
/network/interface/LAN
(config network route policy 0)>
IP routing
719