Edit The Preconfigured Lan1 Bridge - Digi TX54 User Manual

Interfaces

Edit the preconfigured LAN1 bridge

Required configuration items
Enable or disable the bridge.
n
Modify the devices included in the bridge.
n
Additional configuration items
Enable Spanning Tree Protocol (STP).
n
To edit the preconfigured LAN1 bridge:

WebUI
1. Log into the TX54 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Network > Bridges > LAN1.
4. The LAN1 bridge is enabled by default. To disable, uncheck Enable.
5. Modify the list of devices that are a part of the bridge. By default, the LAN1 bridge includes the
following devices:
Ethernet: ETH2
n
Ethernet: ETH3
n
Ethernet: ETH4
n
Wi-Fi access point: Digi AP (Wi-Fi) or Digi AP (Wi-Fi)
n
Wi-Fi access point: Digi AP (Wi-Fi2) (Dual-Wi-Fi variants only)
n
Note The MAC address of the bridge is taken from the first available device in the list.
TX54 User Guide
Bridging
185