Digi TX54 User Manual page 608

Services
c. For Radius, type the radius of the circle. Allowed values are an integer followed by
If Polygonal is selected:
n
a. Click to expand Coordinates.
b. Click  to add a point that represents a vertex of the polygon. A vertex is the point
c. Type the Latitude and Longitude of one of the vertices of the polygon. Allowed
d. Click  again to add an additional point, and continue adding points to create the
For example, to configure a square polygon around the Digi headquarters, configure a
polygon with four points:
This defines a square-shaped polygon equivalent to the following:
7. Define actions to be taken when the device's location triggers a geofence event:
To define actions that will be taken when the device enters the geofence, or is inside
n
the geofence when it boots:
TX54 User Guide
m or km, for example, 100m or 1km.
at which two sides of a polygon meet.
values are:
For Latitude, any integer between -90 and 90, with up to six decimal places.
l
For Longitude, any integer between -180 and 180, with up to six decimal
l
places.
desired polygon.
Location information
608