Example Performance Test Using Iperf3 - Digi TX54 User Manual

Services

Example performance test using iPerf3

On a remote host with Iperf3 installed, enter the following command:
$ iperf3 -c device_ip
where device_ip is the IP address of the TX54 device. For example:
$ iperf3 -c 192.168.2.1
Connecting to host 192.168.2.1, port 5201
[ 4] local 192.168.3.100 port 54934 connected to 192.168.1.1 port 5201
[ ID] Interval
[ 4] 0.00-1.00
[ 4] 1.00-2.00
[ 4] 2.00-3.00
[ 4] 3.00-4.00
[ 4] 4.00-5.00
[ 4] 5.00-6.00
[ 4] 6.00-7.00
[ 4] 7.00-8.00
[ 4] 8.00-9.00
[ 4] 9.00-10.00
- - - - - - - - - - - - - - - - - - - - - - - - -
[ ID] Interval
[ 4] 0.00-10.00
[ 4] 0.00-10.00
iperf Done.
$
TX54 User Guide
Transfer Bandwidth
sec 26.7 MBytes 224 Mbits/sec
sec 28.4 MBytes 238 Mbits/sec
sec 29.8 MBytes 250 Mbits/sec
sec 31.2 MBytes 262 Mbits/sec
sec 32.1 MBytes 269 Mbits/sec
sec 32.5 MBytes 273 Mbits/sec
sec 33.9 MBytes 284 Mbits/sec
sec 33.7 MBytes 282 Mbits/sec
sec 33.5 MBytes 281 Mbits/sec
sec 33.2 MBytes 279 Mbits/sec
Transfer Bandwidth
sec 315 MBytes 264 Mbits/sec
sec 313 MBytes 262 Mbits/sec
Configure the ping responder service
Retr Cwnd
8 2.68 MBytes
29 1.39 MBytes
0 1.46 MBytes
0 1.52 MBytes
0 1.56 MBytes
0 1.58 MBytes
0 1.60 MBytes
0 1.60 MBytes
0 1.60 MBytes
0 1.60 MBytes
Retr
37 sender
receiver
666