Configure Remote Access Mode - Digi TX54 User Manual

Hide thumbs Also See for TX54:

Table of Contents

6. Set the baud rate used by the device to which you want to connect:

(config)>path-parambaudrate rate

7. Set the number of data bits used by the device to which you want to connect:

(config)>path-paramdatabits bits

8. Set the type of parity used by the device to which you want to connect:

(config)>path-paramparity parity

Allowed values are:

The default is none.

9. Set the stop bits used by the device to which you want to connect:

(config)>path-paramstopbits bits

10. Save the configuration and apply the change:

(config)> save

Configuration saved.

11. Type exit to exit the Admin CLI.

Depending on your device configuration, you may be presented with an Access selection

menu. Type quit to disconnect from the device.

Configure Remote Access mode

Remote Access mode allows for remote access to another device that is connected to the serial port.

To change the configuration to match the serial configuration of the device to which you want to

1. Log into the TX54 WebUI as a user with Admin access.

2. On the menu, click System. Under Configuration, click Serial Configuration.

TX54 User Guide

Configure Remote Access mode