Canon imagePRESS 1135 Series Service Manual page 1189

COPIER > OPTION > IMG-FIX
TEMP-05 Adj of fixing temp (sec POD upper deck)
Lv.2 Details Adjusting fixing temperature.
- Plain paper 1 (up to 79 g/m2)/ plain paper 2 (80 to 105 g/m2)
To reduce fixing temperature, reduce the fixing temperature and
the temperature of external heat 1/external heat 2 following the
ratio of 1: 2 (if the fixing temperature is -1 deg C, set external
heat 1/external heat 2 temperature to -2 deg C). To increase
temperature, increase only the fixing temperature while keeping
external heat 1/external heat 2 temperature to 230 deg C.
- Any paper other than plain paper 1 (up to 79 g/m2)/ plain paper 2
(80 to 105 g/m2)
Increase/reduce only the fixing temperature while keeping external
heat 1/ external heat 2 temperature to 230 deg C.
Perform this setting separately with each deck.
Use case In the case of trouble
Adj/set/operate method Enter the setting value, and then press OK key.
Display/adj/set range -10 to 3
Unit 1 deg C
Default value 0
Supplement/memo Increase the range to reduce the temperature because the
fixing roller can be soiled with ink melt with preprint paper (plain
paper reduces the external heat temperature because the
fixing temperature will not be reduced if just adjusting the fixing
temperature).
8
Service Mode > COPIER > OPTION (Mechanical specifications Setting Mode) > IMG-FIX
8 Service Mode > COPIER > OPTION (Mechanical specifications Setting Mode) > IMG-FIX
COPIER > OPTION > IMG-FIX
TEMP-06 Adj of fixing temp (sec POD middle deck)
Lv.2 Details Adjusting fixing temperature.
- Plain paper 1 (up to 79 g/m2)/ plain paper 2 (80 to 105 g/m2)
To reduce fixing temperature, reduce the fixing temperature and
the temperature of external heat 1/external heat 2 following the
ratio of 1:2 (if the fixing temperature is -1 deg C, set external
heat 1/external heat 2 temperature to -2 deg C). To increase
temperature, increase only the fixing temperature while keeping
external heat 1/external heat 2 temperature to 230 deg C.
- Any paper other than plain paper 1 (up to 79 g/m2)/ plain paper 2
(80 to 105 g/m2)
Increase/reduce only the fixing temperature while keeping external
heat 1/ external heat 2 temperature to 230 deg C.
Perform this setting separately with each deck.
Use case In the case of trouble
Adj/set/operate method Enter the setting value, and then press OK key.
Display/adj/set range -10 to 3
Unit 1 deg C
Default value 0
Supplement/memo Increase the range to reduce the temperature because the
fixing roller can be soiled with ink melt with preprint paper (plain
paper reduces the external heat temperature because the
fixing temperature will not be reduced if just adjusting the fixing
temperature).
8-246
8-246