Section 20 List Of Registers - Renesas H8SX/1500 Series Hardware Manual

The register list gives information on the on-chip I/O register addresses, how the register bits are
configured, and the register states in each operating mode. The information is given as shown
below.
1. Register addresses (address order)
• Registers are listed from the lower allocation addresses.
• Registers are classified according to functional modules.
• Undefined and reserved addresses cannot be accessed. Do not access these addresses;
otherwise, the operation when accessing these bits and subsequent operations cannot be
guaranteed.
2. Register bits
• Bit configurations of the registers are listed in the same order as the register addresses.
• Reserved bits are indicated by  in the bit name column.
• Space in the bit name field indicates that the entire register is allocated to either the counter or
data.
• For the registers of 16 or 32 bits, the MSB is listed first.
Byte configuration description order is subject to big endian.
3. Register states in each operating mode
• Register states are listed in the same order as the register addresses.
• For the initialized state of each bit, refer to the register description in the corresponding
section.
• The register states shown here are for the basic operating modes. If there is a specific reset for
an on-chip peripheral module, refer to the section on that on-chip peripheral module.

Section 20 List of Registers

Section 20 List of Registers
Rev. 3.00 Mar. 14, 2006 Page 687 of 804
REJ09B0104-0300