Figure 17.14 Procedure For Programming User Mat In User Boot Mode - Renesas H8SX/1500 Series Hardware Manual

Section 17 Flash Memory (0.18-(m F-ZTAT Version)
Start programming
procedure program
Select on-chip program
to be downloaded and
specify download
destination by FTDAR
Set FKEY to H'A5
Set SCO to 1 after initializing
VBR and execute download
Clear FKEY to 0
DPFR = 0 ?
Set the FPEFEQ
parameter
Initialization
JSR FTDAR setting + 32
FPFR = 0 ?
Disable interrupts
and bus master operation
other than CPU

Figure 17.14 Procedure for Programming User MAT in User Boot Mode

In user boot mode, though the user boot MAT can be seen in the flash memory space, the user
MAT is hidden in the background. Therefore, the user MAT and user boot MAT are switched
while the user MAT is being programmed. Because the user boot MAT is hidden while the user
MAT is being programmed, the procedure program must be executed in an area other than flash
memory. After programming completes, switch the memory MATs again to return to the first
state.
Rev. 3.00 Mar. 14, 2006 Page 614 of 804
REJ09B0104-0300
No
Yes
Download error processing
No
Yes
Initialization error processing
User-boot-MAT
1
selection state
1
Set FMATS to value
other than H'AA
to select user MAT
Set FKEY to H'5A
Set parameter to ER0 and
ER1 (FMPAR and FMPDR)
Programming
JSR FTDAR setting + 16
FPFR = 0 ?
Clear FKEY and programming
Yes
Required data
No
programming is
completed?
Yes
Clear FKEY to 0
Set FMATS to H'AA to
select user boot MAT
End programming
procedure program
Note: The MAT must be switched by FMATS
to perform the programming error
processing in the user boot MAT.
MAT
switchover
No
error processing
MAT
switchover