Renault Laguna III Manual page 503

TOP AND FRONT OF ENGINE
Timing chain: Removal - Refitting
V9X
a Fit the upper timing cover for the back row.
a Fit the back row upper timing cover bolts without
tightening them.
a Tighten the back row upper timing cover bolts in se-
quence.
a Fit the lifting eye on the timing end.
a Refit the timing end lifting eye mounting bolts.
a Fit the coolant pipe at the outlet of the exhaust gas
recirculation solenoid valve to the upper timing cover
of the back row.
a Refit the bolts for the cooling pipe at the outlet of the
exhaust gas recirculation solenoid valve to the upper
timing cover of the back row.
a Refit the air inlet pipe of the damper valve.
a Tighten the clips of the damper valve air inlet pipe.
a Fit the engine wiring support to the upper timing cov-
er of the back row.
a Refit the bolt for the engine wiring support on the up-
per timing cover of the back row.
a Connect the exhaust gas recirculation solenoid
valve connector.
a Clip the fuel lines onto the engine wiring support.
a Refit a new lower timing cover seal.
a Apply drops of SILICONE ADHESIVE SEALANT
(see Vehicle: Parts and consumables for the re-
pair) (04B, Consumables - Products) at (64) on the
new the lower timing cover seal.
a Fit the lower timing cover.
a Fit the lower timing cover bolts without tightening
them.
a Tighten the lower timing cover bolts in the correct or-
der.
a Refit:
- the starter (see 16A, Starting - Charging, Starter:
Removal - Refitting, page 16A-31) ,
- the oil pressure sensor (see 10A, Engine and cyl-
inder block assembly, Oil pressure sensor: Re-
moval - Refitting, page 10A-227) ,
- the oil filter (see 10A, Engine and cylinder block
assembly, Oil filter: Removal - Refitting, page
10A-117) ,
- the alternator (see 16A, Starting - Charging, Al-
ternator: Removal - Refitting, page 16A-1) ,
- the crankshaft seal on the timing side (see 10A,
Engine and cylinder block assembly, Crank-
shaft seal on timing end: Removal - Refitting,
page 10A-134) ,
- the crankshaft accessories pulley (see 11A, Top
and front of engine, Crankshaft accessories
pulley: Removal - Refitting, page 11A-33) ,
- the vacuum pump (see Vacuum pump: Removal
138126
- Refitting) (37A, Mechanical component controls),
- the power-assisted steering pump (see Power-as-
sisted steering pump: Removal - Refitting)
(36B, Power-assisted steering),
11A-125
11A
134883