Renault Laguna III Manual page 302

ENGINE AND CYLINDER BLOCK ASSEMBLY
Oil-coolant heat exchanger: Removal - Refitting
V9X
Special tooling required
Ms. 583 Pipe clamps.
Mot. 1448 Remote operation pliers for
hose clips.
Tightening torquesm
oil-wa t e r h e a t
exchanger bolts
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Remove:
- the engine undertray bolts,
- the engine undertray.
32 N.m
a Fit the tool (Ms. 583) onto the oil-water heat ex-
changer cooling hoses.
a Remove the clips (1) from the oil-water heat ex-
changer cooling hoses using the tool (Mot. 1448).
Note:
Be prepared for the outflow of coolant.
a Disconnect the oil-coolant heat exchanger cooling
hoses.
10A-225
10A
134117