Renault Laguna III Manual page 756

Throttle valve: Removal - Refitting
K4M
a Remove:
- the throttle valve bolts (6) ,
- the throttle valve.
a Remove the throttle valve seal (7) .
REFITTING
I - REMOVAL PREPARATION OPERATION
a Always replace the throttle valve seal.
FUEL MIXTURE
128261
128260
12A-55
a Use SURFACE CLEANER (see Vehicle: Parts
and consumables for the repair) (04B, Consuma-
bles - Products) to clean and degrease:
- the throttle valve joint face if it is to be re-used,
- the inlet manifold seal housing.
WARNING
The joint faces must be clean, dry and free from
grease (avoid finger marks).
WARNING
Do not scrape the joint faces of the aluminium,
any damage caused to the joint face will result in
a risk of leaks.
II - REFITTING OPERATION FOR PART
CONCERNED
a Refit:
- a new seal on the intake distributor,
- the throttle valve.
a In order, torque tighten the throttle valve bolts (10
N.m).
III - FINAL OPERATION.
a Connect to the throttle valve:
- the union of the fuel vapour recirculation solenoid
valve pipe,
- the throttle valve connector.
12A
128261