Renault Laguna III Manual page 242

ENGINE AND CYLINDER BLOCK ASSEMBLY
Crankshaft seal, gearbox end: Removal - Refitting
M9R, and 805 or 809 or 845 or 849
Tightening torquesm
crankshaft cover bolts
(initial torque)
crankshaft cover bolts
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Remove:
- the engine cover,
- the battery (see Battery: Removal - Refitting)
(80A, Battery),
- the battery tray (see Battery tray: Removal - Re-
fitting) (80A, Battery),
- the injection computer (see 13B, Diesel injection,
Diesel injection computer: Removal - Refitting,
page 13B-36) ,
- the air filter unit (see 12A, Fuel mixture, Air filter
unit: Removal - Refitting, page 12A-13) ,
- the engine undertray,
- the front wheels (see Wheel: Removal - Refitting)
(35A, Wheels and tyres),
- the front wheel arch liners (see Front wheel arch
liner: Removal - Refitting) (55A, Exterior protec-
tion),
- the front right-hand driveshaft (see Front right-
hand driveshaft: Removal - Refitting) (29A,
Driveshafts),
- the front left-hand driveshaft (see Front left-hand
driveshaft: Removal - Refitting) (29A, Drive-
shafts),
- the front bumper (see Front bumper: Removal -
Refitting) (55A, Exterior protection),
- the headlights (see Headlight: Removal - Refit-
ting) (80B, Headlights),
- the front end panel (see Front end panel: Remov-
al - Refitting) (42A, Upper front structure).
a Drain:
- the cooling system (see 19A, Cooling, Cooling
system: Draining - Refilling, page 19A-16) ,
- the automatic transmission (see Automatic gear-
box oil: Draining - Filling) (23A, Automatic trans-
mission),
- the refrigerant circuit (see Refrigerant circuit:
5 N.m
Draining - Filling) (62A, Air conditioning).
a Remove:
10 N.m
- the radiator mounting cross member (see Radiator
mounting cross member: Removal - Refitting)
(41A, Front lower structure),
- the rear suspended engine mounting (see 19D,
Engine mounting, Lower engine tie-bar: Re-
moval - Refitting, page 19D-85) ,
- the right-hand suspended engine mounting (see
19D, Engine mounting, Right-hand suspended
engine mounting: Removal - Refitting, page
19D-51) ,
- the left-hand suspended engine mounting (see
19D, Engine mounting, Left-hand suspended
engine mounting: Removal - Refitting, page
19D-1) ,
- the engine and gearbox assembly (see 10A, En-
gine and cylinder block assembly, Engine -
gearbox assembly: Removal - Refitting, page
10A-1) ,
- the automatic transmission (see Automatic gear-
box: Removal - Refitting) (23A, Automatic trans-
mission),
- the drive plate (see 10A, Engine and cylinder
block assembly, Drive plate: Removal - Refit-
ting, page 10A-287) .
10A-165
10A