Timing Belt: Removal - Refitting - Renault Laguna III Manual

TOP AND FRONT OF ENGINE
Timing belt: Removal - Refitting
F4R
Special tooling required
Mot. 1054 TDC setting pin.
Mot. 1496 Camshaft timing tool.
Mot. 1801 Camshaft sprocket locking
tool F4 engines.
Mot. 1509-01 Adapter kit for tool Mot.1509
or Mot.1801
Mot. 1487 Tool for refitting camshaft cov-
ers (57 mm diameter).
Mot. 1488 Tool for refitting camshaft cov-
ers (43 mm diameter).
Tightening torquesm
toothed sprocket nuts
fixed roller bolt
tensioning roller nut (ini-
tial torque)
tensioning roller nut
new inlet camshaft pul-
ley nut
new exhaust camshaft
pulley nut
inlet camshaft pulley nut
exhaust camshaft pul-
ley nut
crankshaft accessories
pulley bolt
engine tie-bar bolt on
the subframe
engine tie-bar bolt on
the engine tie-bar
mounting
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 415, 02A, Lifting equip-
ment).
a Disconnect the battery (see Battery: Removal - Re-
a Remove:
80 Nm
50 Nm
7 Nm
28 Nm
30 Nm
30 Nm
86˚ ± ± ± ± 6˚
86˚ ± ± ± ± 6˚
a Remove:
40 Nm + 110˚ ± ± ± ±
10˚
115 Nm
190 Nm
11A-50
fitting) (MR 415, 80A, Battery).
- the engine cover,
- the front right-hand wheel (see Wheel: Removal -
Refitting) (MR 415, 35A, Wheels and tyres),
- the front right-hand wheel arch liner (see Front
wheel arch liner: Removal - Refitting) (MR 416,
55A, Exterior protection),
- the accessories belt (see 11A, Top and front of
engine, Accessories belt: Removal - Refitting,
page 11A-13) ,
- the engine undertray bolts,
- the engine undertray.
- the engine tie-bar bolt (1) on the engine tie-bar
mounting,
- the engine tie-bar bolt (2) on the subframe,
- the lower linkage.
11A
123177