Rocker Cover: Removal - Refitting - Renault Laguna III Manual

TOP AND FRONT OF ENGINE
Rocker cover: Removal - Refitting
F4R
Special tooling required
Mot. 1716 Removes housing with sili-
cone seals.
Equipment required
roll pin punch
Tightening torquesm
rocker cover bolts (22),
(23), (20), (13)
rocker cover bolts (1) to
(12), (14) to (19), (21),
(24)
rocker cover bolts (22),
(23), (20), (13)
IMPORTANT
Wear latex gloves during the operation.
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 415, 02A, Lifting equip-
ment).
a Disconnect the battery (see Battery: Removal - Re-
fitting) (MR 415, 80A, Battery).
a Remove:
- the engine cover,
- the ignition coils (see 17A, Ignition, Coils: Re-
moval - Refitting, page 17A-1) ,
- the oil decanter (see 11A, Top and front of en-
gine, Oil decanter: Removal - Refitting, page
11A-307) ,
- the front right-hand wheel (see Wheel: Removal -
Refitting) (MR 415, 35A, Wheels and tyres),
- the front right-hand wheel arch liner (see Front
wheel arch liner: Removal - Refitting) (MR 416,
55A, Exterior protection),
- the accessories belt (see 11A, Top and front of
engine, Accessories belt: Removal - Refitting,
page 11A-13) ,
- the engine undertray bolts,
- the engine undertray,
- the crankshaft accessories pulley (see 11A, Top
and front of engine, Crankshaft accessories
pulley: Removal - Refitting, page 11A-33) .
- the right-hand suspended engine mounting (see
19D, Engine mounting, Right-hand suspended
engine mounting: Removal - Refitting, page
19D-51) ,
- the timing belt (see 11A, Top and front of engine,
Timing belt: Removal - Refitting, page 11A-50) ,
- the camshaft seals on the timing end (see 11A,
8 Nm
Top and front of engine, Camshaft seal, timing
end: Removal - Refitting, page 11A-287) .
12 Nm
12 Nm
a Disconnect the connector (3) from the fuel vapour
absorber solenoid valve.
a Unclip:
- the fuel vapour absorber solenoid valve wiring at
(4) ,
- the fuel vapour rebreathing hose.
a Disconnect the fuel supply union on the injector rail.
a Insert the blanking plugs.
11A-139
11A
123144