Renault Laguna III Manual page 146

ENGINE AND CYLINDER BLOCK ASSEMBLY
Engine - gearbox assembly: Removal - Refitting
K4M
a Remove:
- the left-hand suspended engine mounting shaft nut
(47) from the gearbox,
- the nuts (48) from the left-hand suspended engine
mounting rubber pad on the gearbox,
- the left-hand suspended engine mounting rubber
pad from the gearbox.
123457
a Lift the vehicle to remove the "engine-gearbox" as-
sembly.
Note:
Check to ensure that there are no components
obstructing the movement of the body around the
"engine-gearbox" assembly.
REFITTING
I - REFITTING PREPARATION OPERATION
a For standard replacements (see standard replace-
ment) (Technical Note 6020A, 10A, Engine and pe-
ripherals).
II - REFITTING OPERATION FOR PART
CONCERNED
a Fit the "engine-gearbox" assembly into the body.
a Refit:
- the right-hand suspended engine mounting (see
19D, Engine mounting, Right-hand suspended
engine mounting: Removal - Refitting, page
19D-51) ,
- the left-hand suspended engine mounting rubber
pad.
a Tighten to torque:
- the nut on the left-hand suspended engine
mounting shaft on the gearbox (62 N.m),
10A-69
10A
123542