Renault Laguna III Manual page 272

ENGINE AND CYLINDER BLOCK ASSEMBLY
Lower cover: Removal - Refitting
K4M
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a
Note:
Prepare for the engine oil to drain out.
a Remove:
- the sump bolts (3) on the gearbox,
- the cylinder block sump bolts,
- the sump,
- the sump seal.
REFITTING
I - REFITTING PREPARATION OPERATION
a Use SURFACE CLEANER (see Vehicle: Parts
and consumables for the repair) (04B, Consuma-
bles - Products) to clean and degrease:
- the sump joint face if it is to be re-used,
- the cylinder block gasket face.
WARNING
Do not scrape the joint faces of the aluminium,
any damage caused to the joint face will result in
a risk of leaks.
WARNING
The joint faces must be clean, dry and free from
grease (avoid finger marks).
a Alwyas replace the sump gasket.
115584
10A-195
10A