Renault Laguna III Manual page 638

TOP AND FRONT OF ENGINE
Camshaft: Removal - Refitting
M9R
M9R, and 800 or 802 or 803 or 805 or 806 or 808
or 809 or 816 or 845 or 849
a Refit the exhaust gas pressure sensor (see 19B, Ex-
haust, Exhaust gas pressure sensor: Removal -
Refitting, page 19B-93) .
a Refit:
- the timing sprockets (see Timing sprocket: Re-
moval - Refitting) ,
- the timing chain (see 11A, Top and front of en-
gine, Timing chain: Removal - Refitting, page
11A-88) ,
- the new crankshaft seal on the timing end (see
10A, Engine and cylinder block assembly,
Crankshaft seal on timing end: Removal - Refit-
ting, page 10A-134) .
a Fit the flywheel locking tool (Mot. 1431) onto the cyl-
inder block.
a Refit the crankshaft accessories pulley (see 11A,
Top and front of engine, Crankshaft accessories
pulley: Removal - Refitting, page 11A-33) .
a Remove the flywheel locking tool (Mot. 1431).
a Refit:
- the coolant pump (see 19A, Cooling, Coolant
pump: Removal - Refitting, page 19A-66) ,
- the new accessories belt (see 11A, Top and front
of engine, Accessories belt: Removal - Refit-
ting, page 11A-13) .
a Remove the engine from the component support
(see Engine support equipment: Use) .
a Refit the engine - gearbox assembly (see 10A, En-
gine and cylinder block assembly, Engine - gear-
box assembly: Removal - Refitting, page 10A-1) .
a Top up the engine oil (see 10A, Engine and cylin-
der block assembly, Engine oil: Draining - Refill-
ing, page 10A-100) .
11A-260
11A