Renault Laguna III Manual page 358

ENGINE AND CYLINDER BLOCK ASSEMBLY
Flywheel: Removal - Refitting
F4R, and PK4
Special tooling required
Mot. 1677 Flywheel locking tool.
Tightening torquesm
new flywheel bolts
REMOVAL
I - OPERATION FOR REMOVAL OF PART
CONCERNED
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Remove:
- the battery (see Battery: Removal - Refitting)
(80A, Battery),
- the battery tray (see Battery tray: Removal - Re-
fitting) (80A, Battery),
- the air filter unit (see 12A, Fuel mixture, Air filter
unit: Removal - Refitting, page 12A-13) ,
- the starter (see 16A, Starting - Charging, Starter:
Removal - Refitting, page 16A-31) .
a Drain the gearbox (see Manual gearbox oils:
Draining - Filling) (21A, Manual gearbox).
a Remove:
- the front wheels (see Wheel: Removal - Refitting)
(35A, Wheels and tyres),
- the front wheel arch liners (see Front wheel arch
liner: Removal - Refitting) (55A, Exterior protec-
tion),
- the front right-hand wheel driveshaft (see Front
right-hand driveshaft: Removal - Refitting)
(29A, Driveshafts),
- the front left-hand wheel driveshaft (see Front left-
hand driveshaft: Removal - Refitting) (29A,
Driveshafts),
- the radiator mounting cross member (see Radiator
mounting cross member: Removal - Refitting)
(41A, Front lower structure),
- the engine tie-bar (see 19D, Engine mounting,
Lower engine tie-bar: Removal - Refitting, page
19D-85) ,
- the front axle subframe (see Front axle subframe:
Removal - Refitting) (31A, Front axle compo-
nents),
II - OPERATION FOR REMOVAL OF PART
30 N.m + 62˚ ± ± ± ±
CONCERNED
6˚
a Remove:
REFITTING
I - REFITTING PREPARATION OPERATION
a Always replace the flywheel bolts.
a Using SURFACE CLEANER (see Vehicle: Parts
10A-281
- the gearbox (see Manual gearbox: Removal - Re-
fitting) (21A, Manual gearbox),
- the « pressure plate - disc » assembly (see Pres-
sure plate - Disc: Removal - Refitting) (21A,
Manual gearbox).
- the flywheel bolts (1) ,
- the (Mot. 1677) (2) ,
- the flywheel.
and consumables for the repair) (04B, Consum-
ables - Products), clean and degrease the bearing
face of the flywheel on the crankshaft.
10A
128672