Renault Laguna III Manual page 427

TOP AND FRONT OF ENGINE
Crankshaft accessories pulley: Removal - Refitting
K9K
a Turn the crankshaft clockwise (timing end) smoothly
using the bolt of the crankshaft accessories pulley,
until the crankshaft presses against the tool (Mot.
1489) (8) .
a Torque tighten the crankshaft accessories pulley
bolt (120 N.m + 95˚ ± ± ± ± 15˚).
III - FINAL OPERATION
a Remove the (Mot. 1489) from the cylinder block.
a Apply a drop of SILICONE ADHESIVE SEALANT
(see Vehicle: Parts and consumables for the re-
pair) (04B, Consumables - Products) to the thread
of the TDC setting pin plug.
a Torque tighten the TDC setting pin plug (25 N.m).
a Refit:
- the accessories belt (see 11A, Top and front of
engine, Accessories belt: Removal - Refitting,
page 11A-13) ,
- the engine undertray,
- the front section of the front right-hand wheel arch
liner (see Front wheel arch liner: Removal - Re-
fitting) (55A, Exterior protection),
- the front right-hand wheel (see Wheel: Removal -
Refitting) (35A, Wheels and tyres),
- the engine cover.
14489
11A-49
11A