Renault Laguna III Manual page 425

TOP AND FRONT OF ENGINE
Crankshaft accessories pulley: Removal - Refitting
K9K
Special tooling required
Mot. 1489 TDC locating pin.
Tightening torquesm
the crankshaft accesso-
ries pulley bolt
TDC setting pin plug
WARNING
Do not run the engine without the accessories belt
to avoid damaging the crankshaft accessories pul-
ley.
IMPORTANT
Wear protective gloves during the operation.
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Remove:
- the engine cover,
- the front right-hand wheel (see Wheel: Removal -
Refitting) (35A, Wheels and tyres),
- the front section of the front right-hand wheel arch
liner (see Front wheel arch liner: Removal - Re-
fitting) (55A, Exterior protection),
- the engine undertray bolts,
- the engine undertray,
- the accessories belt (see 11A, Top and front of
engine, Accessories belt: Removal - Refitting,
page 11A-13) .
II - OPERATION FOR REMOVAL OF PART
CONCERNED
120 N.m + 95˚
± ± ± ± 15˚
25 N.m
a Lock the flywheel using a screwdriver (1) .
a Remove:
11A-47
- the crankshaft accessories pulley bolt (2) ,
- the crankshaft accessories pulley (3) .
11A
135405
135491