Renault Laguna III Manual page 465

TOP AND FRONT OF ENGINE
Timing belt: Removal - Refitting
K4M
a Refit the lower timing cover flap, checking that the
locating pin (43) fits properly in the notch (44) .
III - FINAL OPERATION
a Refit:
- a new inlet camshaft plug using the (Mot. 1487),
- a new exhaust camshaft plug using the (Mot.
1488),
- the lifting eye.
a Torque tighten the flywheel end lifting eye bolts
(10 N.m).
a Fit the engine wiring.
a Clip:
- the engine wiring connector onto the lifting eye,
- the gearbox breather pipe onto the lifting eye.
a Clip the heater matrix cooling hose onto the lifting
eye.
a Apply a drop of SILICONE ADHESIVE SEALANT
(see Vehicle: Parts and consumables for the re-
pair) (04B, Consumables - Products) to the thread
of the TDC pin plug.
a Tighten to torque the TDC pin plug (20 N.m).
a Refit the upper timing cover.
a Torque tighten:
- the upper timing cover bolts (46 N.m),
- the upper timing cover nuts (46 N.m).
a Refit:
- the right-hand suspended engine mounting (see
19D, Engine mounting, Right-hand suspended
engine mounting: Removal - Refitting, page
19D-51) ,
- the rear suspended engine mounting.
a Torque tighten:
- the rear suspended engine mounting bolt on
the rear suspended engine mounting support
(180 N.m),
- the rear suspended engine mounting bolt on
the subframe (180 N.m).
a Refit:
- the accessories belt (see 11A, Top and front of
engine, Accessories belt: Removal - Refitting,
page 11A-13) ,
- the throttle valve (see 12A, Fuel mixture, Throttle
valve: Removal - Refitting, page 12A-49) ,
109052
- the air filter unit (see 12A, Fuel mixture, Air filter
unit: Removal - Refitting, page 12A-13) ,
- the engine undertray,
- the front right-hand wheel arch liner (see Front
wheel arch liner: Removal - Refitting) (55A, Ex-
terior protection),
- the front right-hand wheel (see Wheel: Removal -
Refitting) (35A, Wheels and tyres).
- the engine cover,
a Connect the battery (see Battery: Removal - Refit-
ting) (80A, Battery).
11A-87
11A