Renault Laguna III Manual page 192

ENGINE AND CYLINDER BLOCK ASSEMBLY
Engine oil: Draining - Refilling
V9X
Equipment required
oil recovery tray
oil change wrench
torque wrench
oil change end piece with an 8 mm square drive
Tightening torquesm
engine oil sump drain
plug
Average oil capacity (adjust with
Engine
Draining
V9X 6.5
I - RECOMMENDATIONS FOR REPAIR
a Direction of fitting for a drain plug seal.
44 N.m
dipstick) (l)
O i l c h a n ge
plus oil filter
replacement
6.8
a There is no direction of fitting for a seal fitted with a
rubber lip.
IMPORTANT
Wear leaktight gloves (Nitrile type) for this opera-
tion.
WARNING
Always check the oil level using the dipstick.
Do not exceed the maximum level on the dipstick
(could destroy the engine).
Correct the engine oil level if necessary before
delivering the vehicle to the customer.
Note:
When topping up the engine oil, always leave at
least 10 minutes before checking the level with a
dipstick.
II - PARTS AND CONSUMABLES FOR THE REPAIR
WORK
a parts always to be replaced: Drain plug seal on
engine oil sump (10,03,01,04).
a Consumable:
- engine oil (see Engine oil: Specifications) (Tech-
nical Note 6013A, 04A, Lubricants).
10A-115
10A
129066