Renault Laguna III Manual page 246

ENGINE AND CYLINDER BLOCK ASSEMBLY
Crankshaft seal, gearbox end: Removal - Refitting
K4M
Special tooling required
Mot. 1129-01 Tool for fitting the crankshaft
seal, flywheel end (80 x 100 x
8 seal).
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Remove:
- the engine cover,
- the battery (see Battery: Removal - Refitting)
(80A, Battery)
- the battery tray (see Battery tray: Removal - Re-
fitting) (80A, Battery),
- the air filter box (see 12A, Fuel mixture, Air filter
unit: Removal - Refitting, page 12A-13) ,
- the starter (see 16A, Starting - Charging, Starter:
Removal - Refitting, page 16A-31) ,
- the front wheels (see Wheel: Removal - Refitting)
(35A, Wheels and tyres),
- the front wheel arch liners (see Front wheel arch
liner: Removal - Refitting) (55A, Exterior protec-
tion),
- the engine undertray bolts,
- the engine undertray.
a Drain the manual gearbox (see Manual gearbox
oils: Draining - Filling) (21A, Manual gearbox).
a Remove:
- the front left-hand wheel driveshaft (see Front left-
hand driveshaft: Removal - Refitting) (29A,
Driveshafts),
- the front right-hand wheel driveshaft (see Front
right-hand driveshaft: Removal - Refitting)
(29A, Driveshafts),
- the differential output seals (see Differential out-
put seal: Removal - Refitting) (21A, Manual gear-
box),
- the radiator mounting cross member (see Radiator
mounting cross member: Removal - Refitting)
(41A, Front lower structure),
- the front axle subframe (see Front axle subframe:
Removal - Refitting) (31A, Front axle compo-
nents),
- the manual gearbox (see Manual gearbox: Re-
moval - Refitting) (21A, Manual gearbox),
- the « pressure plate - disc » assembly (see Pres-
sure plate - Disc: Removal - Refitting) (20A,
Clutch),
- the flywheel (see 10A, Engine and cylinder block
assembly, Flywheel: Removal - Refitting, page
10A-277) (20A, Clutch).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Remove the crankshaft seal (1) using a screwdriver.
Note:
Take care not to damage the crankshaft mating
face.
REFITTING
I - REFITTING PREPARATION OPERATION
a Always replace the crankshaft seal.
10A-169
10A
131093