Renault Laguna III Manual page 309

ENGINE AND CYLINDER BLOCK ASSEMBLY
Oil pressure sensor: Removal - Refitting
K9K
Special tooling required
Mot. 1495 22 mm socket for removal -
refitting of oxygen sensors -
1/2" square drive and 24 mm
hexagonal ext.
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 415, 02A, Lifting equip-
ment).
a Remove:
- the engine undertray bolts,
- the engine undertray.
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Disconnect the oil pressure sensor connector (1) .
a Remove the oil pressure sensor using the (Mot.
1495).
REFITTING
I - REFITTING PREPARATIONS OPERATION
a Wipe any oil run-off with a cloth.
a Always replace the oil pressure sensor.
II - REFITTING OPERATION FOR PART
CONCERNED
a Refit the new oil pressure sensor.
a Tighten the new oil pressure sensor using the (Mot.
1495).
a Connect the new oil pressure sensor connector.
III - FINAL OPERATION.
a Refit:
- the engine undertray,
- the engine undertray bolts.
123835
10A-232
10A