Renault Laguna III Manual page 133

ENGINE AND CYLINDER BLOCK ASSEMBLY
Engine - gearbox assembly: Removal - Refitting
K9K
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a
Note:
Ensure that the (Mot. 1390) is correctly posi-
tioned under the multifunction support at (33) .
a Position the (Mot. 1390) under the "engine - gear-
box" assembly.
a Remove the right-hand suspended engine mounting
(see 1 9 D , Engine mounting, Right-hand sus-
pended engine mounting: Removal - Refitting,
page 19D-51) .
112813
a Remove the left-hand suspended engine mounting
shaft nut (34) .
a Remove the left-hand suspended engine mounting
shaft rubber pad with a copper hammer.
a Mark the position of the left-hand suspended engine
mounting rubber pad on the left-hand suspended
engine mounting support using a indelible pencil.
a Remove:
112814
- the nuts (35) from the left-hand suspended engine
mounting rubber pad,
- the rubber pad from the left-hand suspended en-
gine mounting
a Remove the "engine - gearbox" assembly from the
engine compartment using the (Mot. 1390).
a Strap up the engine - gearbox assembly using the
(Mot. 1390).
REFITTING
I - REFITTING PREPARATION OPERATION
a Always replace the exhaust flange seal.
II - REFITTING OPERATION FOR PART
CONCERNED
a Detach the engine - gearbox assembly from the
(Mot. 1390).
10A-56
10A
123788