Renault Laguna III Manual page 787

Inlet distributor: Removal - Refitting
K4M
Tightening torquesm
bolts 1 to 5 of the inlet
manifold
bolts 6 to 8 of the inlet
manifold
IMPORTANT
During this operation, be sure to:
- refrain from smoking or bringing red hot objects
close to the working area,
- be careful of fuel splashes when disconnecting the
union.
IMPORTANT
Wear leaktight gloves (Nitrile type) for this opera-
tion.
WARNING
To avoid any corrosion or damage, protect the
areas on which fuel is likely to run.
WARNING
To prevent impurities from entering the circuit, plugs
must be fitted to the openings of all the fuel circuit
components exposed to the open air.
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Remove:
- the engine cover,
- the throttle valve (see 12A, Fuel mixture, Throttle
valve: Removal - Refitting, page 12A-49) .
FUEL MIXTURE
9 N.m
12 N.m
12A-86
a Disconnect:
- all coil connectors (1) ,
- the air temperature sensor connector (2) .
a Unclip the coil wiring.
a Move the coil wiring (3) to one side.
12A
128403
128404