Renault Laguna III Manual page 182

ENGINE AND CYLINDER BLOCK ASSEMBLY
Engine oil: Draining - Refilling
F4R
Equipment required
oil recovery tray
oil change wrench
oil change end piece with an 8 mm square drive
Tightening torquesm
drain plug
Average oil capacity
(adjusting using dipstick) (l)
Engine
Oil change with-
o u t
replacement
F4R 5.2
IMPORTANT
Wear leaktight gloves (Nitrile type) for this opera-
tion.
PARTS AND CONSUMABLES FOR THE
REPAIR WORK
a parts always to be replaced: Drain plug seal on
engine oil sump (10,03,01,04)
I - OIL SERVICE
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
20 N.m
Oil change with
fi l t e r filter replace-
ment
5.4
a Remove:
- the filler cap (1) ,
- the dipstick (2) ,
- the engine undertray.
a Place the oil recovery tray under the engine.
a Remove:
- the drain plug (3) from the engine oil sump using a
oil change wrench
- the engine oil sump drain plug seal.
a Let the engine oil run into the oil recovery tray.
10A-105
10A
123137
123178