Renault Laguna III Manual page 348

ENGINE AND CYLINDER BLOCK ASSEMBLY
Multifunction support: Removal - Refitting
K9K
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 415, 02A, Lifting equip-
ment).
a Disconnect the battery (see Battery: Removal - Re-
fitting) (MR 415, 80A, Battery).
a Remove the front engine cover.
a Drain the refrigerant circuit (see Refrigerant circuit:
Draining - Filling) (MR 415, 62A, Air conditioning).
a Remove:
- the front right-hand wheel (see Wheel: Removal -
Refitting) (MR 415, 35A, Wheels and tyres),
- the front right-hand wheel arch liner (see Front
wheel arch liner: Removal - Refitting) (MR 416,
55A, Exterior protection),
- the accessories belt (see 11A, Top and front of
engine, Accessories belt: Removal - Refitting,
page 11A-13) ,
- the engine undertray bolts,
- the engine undertray,
- the front bumper (see Front bumper: Removal -
Refitting) (MR 416, 55A, Exterior protection),
- the headlights (see Headlight: Removal - Refit-
ting) (MR 415, 80B, Headlights),
- the front end panel (see Front end panel: Remov-
al - Refitting) (MR 416, 42A, Upper front struc-
ture),
- the alternator (see 16A, Starting - Charging, Al-
ternator: Removal - Refitting, page 16A-1) ,
- the air conditioning compressor (see Compressor:
Removal - Refitting) (MR 415, 62A, Air condition-
ing).
II - REMOVAL OPERATION FOR PART
CONCERNED
a Remove:
- the multifunction support bolts (1) ,
- the multifunction support.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
a Refit:
- the multifunction support,
- the multifunction support bolts.
10A-271
10A
123832