Renault Laguna III Manual page 193

ENGINE AND CYLINDER BLOCK ASSEMBLY
Engine oil: Draining - Refilling
V9X
III - DRAINING
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Remove:
- the engine oil filler cap (1) ,
- the dipstick (2) ,
- the engine undertray bolts,
- the engine undertray.
a Place the oil recovery tray under the engine.
a Remove the drain plug (3) from the engine oil sump
using the oil change wrench.
a Let the engine oil run into the oil recovery tray.
133894
a Remove the drain plug seal.
a Fit a new seal onto the engine oil drain plug.
a Torque tighten the engine oil sump drain plug (44
N.m) using a torque wrench and a oil change end
piece with an 8 mm square drive.
a Wipe the oil drips on the sump using a cloth.
a Remove the oil recovery tray.
a Refit the engine undertray.
IV - FILLING
a Position the vehicle back on the ground.
a Fill the engine with oil, observing the recommended
amount.
a Wait at least 10 minutes.
a Check the oil level using the dipstick.
a Top up the engine oil level if necessary.
a Refit:
- the dipstick,
- the engine oil filler cap.
Note:
Lubricate the seal of the engine oil filler cap
before refitting it.
10A-116
10A
133896