Renault Laguna III Manual page 397

TOP AND FRONT OF ENGINE
Accessories belt: Removal - Refitting
M4R
Special tooling required
Mot. 1368 Tool for tightening eccentric
tensioning roller bolt. 8 mm
Torx wrench and 12.7 mm
square.
Tightening torquesm
tensioning roller bolt
WARNING
The tensioning roller must be replaced when the
belt is replaced.
WARNING
Do not run the engine without the accessories belt
to avoid damaging the crankshaft accessories pul-
ley.
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 415, 02A, Lifting equip-
ment).
a Remove:
- the engine cover,
- the front right-hand wheel (see Wheel: Removal -
Refitting) (MR 415, 35A, Wheels and tyres),
- the front right-hand wheel arch liner (see Front
wheel arch liner: Removal - Refitting) (MR 416,
55A, Exterior protection).
II - REMOVAL OPERATION FOR PART
CONCERNED
40 Nm
a Turn the accessories belt tensioning roller clockwise
using a 14 mm spanner.
a Lock the tensioning roller using a 6 mm Allen key (1)
.
a Remove the accessories belt.
11A-19
11A
115082
115083