Renault Laguna III Manual page 870

Turbocharger: Removal - Refitting
V9X
- the turbocharger washers,
- the turbocharger air outlet pipe seal,
- the exhaust gas cooler studs on the turbocharger,
if they were loosened during the removal operation,
- the exhaust gas cooler nuts on the turbocharger.
a Using SURFACE CLEANER (see Vehicle: Parts
and consumables for the repair) (04B, Consuma-
bles - Products), clean and degrease the bearing fa-
ces of:
- the exhaust manifolds,
- the turbocharger,
a Remove the turbocharger air outlet pipe seal using a
tweezers.
TURBOCHARGING
115068
12B-30
a
Note:
Check that the turbocharger air outlet pipe seal is
fitted the correct way round.
a Refit a new seal for the turbocharger air outlet pipe.
If replacing the turbocharger
a Refit:
- the turbocharger upper oil pipe (see 12B, Turbo-
charging, Turbocharger oil pipe: Removal - Re-
fitting, page 12B-35) ,
- the exhaust gas pressure sensor (see 19B, Ex-
haust, Exhaust gas pressure sensor: Removal -
Refitting, page 19B-93) ,
- the exhaust gas temperature sensor (see 19B, Ex-
haust, Exhaust gas temperature sensor: Re-
moval - Refitting, page 19B-85) ,
- the turbocharger coolant pipe (see Turbocharger
coolant pipe: Removal - Refitting) .
II - REFITTING OPERATION FOR PART
CONCERNED
a Refit new turbocharger studs.
a Torque tighten the turbocharger studs (10 N.m).
a Refit:
- new seals of the front and back exhaust manifolds,
12B
115069