Renault Laguna III Manual page 880

Turbocharger oil pipe: Removal - Refitting
M9R
Tightening torquesm
turbocharger oil pipe
bolts
turbocharger oil supply
pipe hollow bolt on the
cylinder block
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Disconnect the battery (see Battery: Removal - Re-
fitting) (80A, Battery).
a Remove:
- the engine undertray bolts,
- the engine undertray.
a Drain the gearbox (see Manual gearbox oils:
Draining - Filling) (21A, Manual gearbox).
a Remove:
- the front right-hand driveshaft (see Front right-
hand driveshaft: Removal - Refitting) (29A,
Driveshafts),
- the differential output seal (see Differential output
seal: Removal - Refitting) (21A, Manual gear-
box),
- the engine tie-bar (see 19D, Engine mounting,
Lower engine tie-bar: Removal - Refitting, page
19D-85) .
M9R, and 742 or 744 or 746 or 748 or 754
a Remove the catalytic converter (see 19B, Exhaust,
Catalytic converter: Removal - Refitting, page
19B-32) .
M9R, and 800 or 802 or 805 or 806 or 808 or 809
or 816 or 845 or 849
a Remove the catalytic pre-converter (see 19B, Ex-
haust, Catalytic pre-converter: Removal - Refit-
ting, page 19B-22) .
TURBOCHARGING
10 N.m
16 N.m
12B-40
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Remove:
- the turbocharger oil pipe bolt (1) on the cylinder
block,
- the turbocharger oil pipe bolts (2) on the turbo-
charger,
- the turbocharger oil supply pipe hollow bolt (3) on
the cylinder block,
- the turbocharger oil pipes.
REFITTING
I - REFITTING PREPARATION OPERATION
a Parts always to be replaced:
- the turbocharger oil pipes.
a Lubricate the new turbocharger oil pipe O-ring, cylin-
der block end.
a Remove the protective plug on the oil supply union,
cylinder block end.
12B
123625