Renault Laguna III Manual page 423

TOP AND FRONT OF ENGINE
Crankshaft accessories pulley: Removal - Refitting
V9X
Tightening torquesm
crankshaft accessories
pulley bolt
WARNING
Do not run the engine without the accessories belt
to avoid damaging the crankshaft accessories pul-
ley.
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Disconnect the battery (see Battery: Removal - Re-
fitting) (80A, Battery).
a Remove:
- the front right-hand wheel (see Wheel: Removal -
Refitting) (35A, Wheels and tyres),
- the front right-hand wheel arch liner (see Front
wheel arch liner: Removal - Refitting) (55A, Ex-
terior protection),
- the engine undertray bolts,
- the engine undertray,
- the lower engine tie-bars (see 1 9 D, Engine
mounting, Lower engine tie-bar: Removal - Re-
fitting, page 19D-85) ,
- the right-hand suspended engine mounting (see
19D, Engine mounting, Right-hand suspended
engine mounting: Removal - Refitting, page
19D-51) ,
- the accessories belt (see 11A, Top and front of
engine, Accessories belt: Removal - Refitting,
page 11A-13) .
II - OPERATION FOR REMOVAL OF PART
CONCERNED
50 Nm + 85˚ ± ± ± ±
6˚
a Immobilise the crankshaft accessories pulley using
a Remove the crankshaft accessories pulley bolt.
a Remove:
11A-45
the (1) .
- the crankshaft accessories pulley washer (2) ,
- the crankshaft accessories pulley (3) .
11A
124167
124165