Renault Laguna III Manual page 271

ENGINE AND CYLINDER BLOCK ASSEMBLY
Lower cover: Removal - Refitting
K4M
Tightening torquesm
sump bolts
sump bolts on the gear-
box
sump bolt on the multi-
function support
relay bearing bolts on
the sump
right-hand transmission
bracket bolt on the relay
bearing
IMPORTANT
Wear leaktight gloves (nitrile type) for this opera-
tion.
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Remove:
- the engine undertray bolts,
- the engine undertray.
a Drain the engine oil (see 10A, Engine and cylinder
block assembly, Engine oil: Draining - Refilling,
page 10A-100) .
a Remove:
- the oil level sensor (see 10A, Engine and cylinder
block assembly, Oil level sensor: Removal - Re-
fitting, page 10A-237) ,
- the rear suspended engine mounting (see 19D,
Engine mounting, Lower engine tie-bar: Re-
moval - Refitting, page 19D-85) .
14 N.m
44 N.m
21 N.m
44 N.m
21 N.m
a Remove:
- the right-hand driveshaft bracket bolt (1) on the re-
lay bearing,
- the bolts (2) from the relay bearing,
- the relay bearing,
- the sump bolts from the multifunction support.
10A-194
10A
128800