Renault Laguna III Manual page 792

Inlet distributor: Removal - Refitting
V4Y
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Remove:
- the inlet manifold bolts (12) ,
- the inlet manifold,
- the inlet manifold seal.
REFITTING
I - REFITTING PREPARATION OPERATION
a parts always to be replaced: inlet distributor seal
(10,07,01,07).
II - REFITTING OPERATION FOR PART
CONCERNED
a Refit:
- a new seal on the inlet manifold,
- the inlet manifold,
- the intake distributor bolts.
FUEL MIXTURE
133475
12A-91
a Pretighten to torque and in order the inlet manifold
mountings(initial torque) (7 N.m).
a Tighten to torque and in order the inlet manifold
mountings(torque) (13 N.m).
III - FINAL OPERATION
a Fit the support of the ignition coil connector on the
inlet manifold.
a Torque tighten the support bolt of the ignition coil
connector on the inlet manifold (25 N.m).
a Connect the cooling hoses to the inlet manifold.
a Fit the cooling hose clips using the tool (Mot. 1448).
a Remove the tool (Ms. 583) from the cooling hoses.
a Fit the engine cover support.
a Refit:
- the engine cover support bolt,
- the fuel vapour recirculation solenoid valve.
a Connect the fuel vapour recirculation solenoid valve
hose.
a Fit the fuel vapour recirculation hose clip using the
tool (Mot. 1448).
a Clip on the fuel vapour recirculation hose.
a Torque tighten the fuel vapour recirculation sole-
noid valve bolts (9 N.m).
a Connect the connector of the fuel vapour recircula-
tion solenoid valve.
12A
133475