Renault Laguna III Manual page 224

ENGINE AND CYLINDER BLOCK ASSEMBLY
Crankshaft seal on timing end: Removal - Refitting
V9X
Special tooling required
Mot. 1577 Lip seal extractor (shaft diam-
eter 28 mm to 42 mm).
Mot. 1912 Adapter for seal extractor
Mot.1577 (shaft diameter 36
mm to 60 mm)
Mot. 1905 Crankshaft seal fitting tool
(timing end)
Tightening torquesm
right-hand engine tie-
bar bolts
left-hand engine tie-bar
bolts
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Remove:
- the engine cover,
- the front right-hand wheel (see Wheel: Removal -
Refitting) (35A, Wheels and tyres),
- the front right-hand wheel arch liner (see Front
wheel arch liner: Removal - Refitting) (55A, Ex-
terior protection),
- the engine undertray.
180 N.m
105 N.m
a Remove:
- the bolts (1) of the lower engine tie-bars,
- the left-hand lower engine tie-bar (2) ,
- the right-hand lower engine tie-bar (3) ,
- the right-hand suspended engine mounting (see
19D, Engine mounting, Right-hand suspended
engine mounting: Removal - Refitting, page
19D-51) ,
- the accessories belt (see 11A, Top and front of
engine, Accessories belt: Removal - Refitting,
page 11A-13) ,
- the crankshaft accessories pulley (see 11A, Top
and front of engine, Crankshaft accessories
pulley: Removal - Refitting, page 11A-33) .
10A-147
10A
133896