TIGHTENING TORQUES (in daN.m)
Tensioner nut
Fixed roller nut
Timing cover bolt
Suspended mounting limiter bolt
Suspended mounting cover bolt
Wheel bolts
REMOVAL
Disconnect the battery.
If necessary, place the vehicle on a two-post lift.
Remove the right-hand side member soundproofing.
Remove the travel limiter linkage.
Turn the steering to full right-hand lock.
Remove the front right wheel arch cover.
TOP AND FRONT OF ENGINE
Timing belt
Timing belt
SPECIAL TOOLING REQUIRED
Mot. 1390
Engine and transmission
assembly mounting tool
Mot. 1536
TDC setting pin
Mot. 1534
Inlet camshaft timing/locking
tool
Mot. 1537
Exhaust camshaft timing/
locking tool
2.6
3.3
1
10.5
6.2
10
Adjust the engine cylinder n˚ 1 to top dead centre
(marking (1) on the crankshaft pulley) and pin the
crankshaft after removing the cap (A).
11-2
11
15854M1