Clutch Pipe And Hose - Subaru IMPREZA 2002 Service Manual

CLUTCH PIPE AND HOSE
CLUTCH SYSTEM
I
7. Clutch Pipe and Hose
A: REMOVAL
1) Remove the air cleaner case. (Non-turbo model)
<Ref. to IN(S0HC)-6, REMOVAL, Air Cleaner
Case.>
2) Remove the intercooler. (Turbo model) <Ref. to
IN(D0HC TURBO)-IO, REMOVAL, Intercooler.>
3) Drain the clutch fluid. <Ref. to CL-23, Clutch Flu-
id.>
4) Remove the clutch pipe from the clutch hose and
master cylinder.
5) Pull out the clamp, then remove the clutch hose
from bracket
I
B: INSTALLATION
Install in the reverse order of removal.
NOTE:
Bleed the clutch fluid. <Ref. to CL-24, Clutch Fluid
Air Bleeding.>
Tightening torque:
T1: 15 N.m (1.5 kgf-m, 10.8 ft-lb)
T2: 18 N-m (1.8 kgf-m, 13.0 ft-16)
T3: 25 N-m (2.5 kgf-m, 18.1 ft-16)
(A) Clamp
(B)
Clutch hose
6) Remove the hose from operating cylinder.
7) Remove the bracket.
(A) Clutch pipe
(B) Clip
(C) Clutch hose
C: INSPECTION
Check pipes and hoses for cracks, breakage or
damage. Check joints for fluid leakage. If any
cracks, breakage, damage or leakage is found, re-
pair or replace the applicable pipe or hose.
'\
'\
CL-22