Operating Cylinder - Subaru 2009 IMPREZA Service Manual

CLUTCH SYSTEM

5. Operating Cylinder

A: REMOVAL
NOTE:
The illustration below is suitable for every model.
Perform the same procedures for the other models.
1) Remove the air intake chamber. (Non-turbo
model) <Ref. to IN(H4SO)-7, REMOVAL, Air Intake
Chamber.>
2) Remove the intercooler. (Turbo model)
<Ref. to IN(H4DOTC)-13, REMOVAL, Intercool-
er.>
3) Disconnect the clutch hose from the operating
cylinder.
CAUTION:
• Cover the hose joint to prevent the clutch flu-
id from flowing out.
• Do not loosen or remove the cap bolt. (Turbo
model)
(A)
(A) Clutch hose
(B) Operating cylinder
4) Remove the operating cylinder from the trans-
mission.
Operating Cylinder
(B)
CL-00353
CL-00356
CL-16
B: INSTALLATION
NOTE:
The illustration below is suitable for every model.
Perform the same procedures for the other models.
1) Install in the reverse order of removal.
NOTE:
Before installing the operating cylinder, apply
grease (KOPR-KOTE: Part No. 003603001) to the
contact point of the release lever and operating cyl-
inder.
Tightening torque:
T1: 18 N·m (1.8 kgf-m, 13.3 ft-lb)
T2: 37 N·m (3.8 kgf-m, 27.3 ft-lb)
T1
NOTE:
• Be sure to install the clutch hose with the mark
side facing upward.
• Be careful not to twist the clutch hose during in-
stallation.
(C)
(A) Mark
(B) Clutch hose
(C) Operating cylinder
2) After bleeding air from the operating cylinder,
ensure that the clutch operates properly. <Ref. to
CL-22, Clutch Fluid Air Bleeding.>
T2
T2
CL-00359
(A)
(B)
CL-00041