Compulsory Valve Operation Check Mode - Subaru Legacy 2002 Service Manual

COMPULSORY VALVE OPERATION CHECK MODE

Engine (DIAGNOSTICS)
14. Compulsory Valve
Operation Check Mode
A: OPERATION
1) Prepare Subaru Select Monitor kit. <Ref. to
EN(H6)-8, PREPARATION
Description.>
2) Connect diagnosis cable to Subaru Select
Monitor.
3) Insert cartridge into Subaru Select Monitor.
<Ref. to EN(H6)-8, PREPARATION TOOL, Gen-
eral Description.>
4) Connect test mode connector at the lower por-
tion of instrument panel (on the driver's side), to
the side of the center console box.
S048528
S048528A16
TOOL, General
S2M0285
S2M0286A
B2M3716
5) Connect Subaru Select Monitor to data link
connector.
(1) Connect Subaru Select Monitor to data link
connector located in the lower portion of the
instrument panel (on the driver's side).
(2) Connect diagnosis cable to data link con-
nector.
CAUTION:
Do not connect scan tools except for Subaru
Select Monitor and OBD-II general scan tool.
6) Turn ignition switch to ON (engine OFF) and
Subaru Select Monitor switch to ON.
(A) Power switch
7) On the
the {2. Each System Check} and press the [YES]
key.
8) On the
screen, select the {Engine Control System} and
press the [YES] key.
9) Press the [YES] key after displayed the infor-
mation of engine type.
10) On the
select the {System Operation Check Mode} and
press the [YES] key.
11) On the
display screen, select the {Actuator ON/OFF
Operation} and press the [YES] key.
12) Select the desired compulsory actuator on the
Actuator ON/OFF Operation
and press the [YES] key.
EN(H6)-50
Main Menu display screen, select
System Selection Menu
Engine Diagnosis display screen,
System Operation Check Mode
display screen
B2M2960
S2M0288E
display