Huawei Quidway NetEngine80E Configuration Manual page 643
Universal service router, ip routing
Hide thumbs
Also See for Quidway NetEngine80E:
- Configuration manual - reliability (1432 pages) ,
- Configuration manual (341 pages) ,
- Installation manual (169 pages)
Advertisement
HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
l
----End
Checking the Configurations
After configuring dynamic BFD for IPv6 IS-IS, you can check information about the BFD
session and BFD for IPv6 IS-IS on an interface.
l
Issue 02 (2014-09-30)
ipv6 bfd all-interfaces { min-rx-interval receive-interval | min-tx-
interval transmit-interval | detect-multiplier multiplier-value | frr-
binding } *
The parameters for establishing BFD sessions are set for all interfaces.
The command execution result is applicable to BFD session parameters on all IS-IS
interfaces.
7.
Run:
quit
The system view is displayed.
To disable the BFD function on an interface, run the isis ipv6 bfd block command in
the interface view to disable the interface from establishing BFD sessions.
Enable dynamic BFD on an IS-IS IPv6 interface.
1.
Run:
system-view
The system view is displayed.
2.
Run:
bfd
BFD is enabled globally.
3.
Run:
quit
The system view is displayed.
4.
Run:
interface interface-type interface-number
The view of the specified interface is displayed.
5.
Run:
isis ipv6 bfd enable
BFD is enabled on the interface.
6.
(Optional) Run:
isis ipv6 bfd { min-rx-interval receive-interval | min-tx-interval
transmit-interval | detect-multiplier multiplier-value | frr-binding }
Run this command when BFD session parameters need to be configured for a specified
interface.
Run the display isis [ process-id | vpn-instance vpn-instance-name ] ipv6 bfd session
{ all | peer ipv6-address | interface interface-type interface-number } command to check
information about an BFD session.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 IS-IS Configuration
*
618
Hide quick links:
Advertisement
