Configuration Examples - Huawei Quidway NetEngine80E Configuration Manual

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
Context
The OSPFv3 adjacency is removed when you reset the OSPFv3 connection by using the reset
ospfv3 command. Exercise caution when running this command.
After modifying the OSPFv3 routing policy or protocol, reset the OSPFv3 connection to validate
the modification. To reset OSPFv3 connections, run the following reset ospfv3 command in the
user view.
Procedure
l
----End

6.16 Configuration Examples

This section provides several configuration examples of OSPFv3 together with the Networking
diagram. The configuration examples explain networking requirements, configuration notes,
and configuration roadmap.
Follow-up Procedure
6.16.1 Example for Configuring OSPFv3 Areas
This part provides an example for configuring basic OSPFv3 functions. Detailed operations
include enabling OSPFv3 on each router and specifying network segments in different areas.
Networking Requirements
As shown in
three areas. Router B and Router C serve as ABRs to forward the inter-area routes.
It is required that Area 2 be configured as a stub area to decrease the LSAs advertised to this
area, without affecting route reachability.
Issue 02 (2014-09-30)
NOTICE
To validate the new configuration, run the following commands:
– reset ospfv3 { process-id | all } [ graceful-restart [ extend-period period ] ]
– reset ospfv3 { process-id | all } counters [ neighbor [ interface-type interface-
number ] [ router-id ] ]
NOTE
This document takes interface numbers and link types of the NE40E-X8 as an example. In working
situations, the actual interface numbers and link types may be different from those used in this document.
Figure 6-1, all routers run OSPFv3. The entire autonomous system is divided into
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 OSPFv3 Configuration

465