Huawei Quidway NetEngine80E Configuration Manual page 174

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
Figure 2-9 Networking for configuring permanent advertisement of IPv4 static routes
RouterA
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
Data Preparation
To complete the configuration, you need the following data:
l
l
Procedure
Step 1 Configure an IP address for each interface. This example assumes that you know the
configuration method and no details are provided here.
Issue 02 (2014-09-30)
POS1/0/0
40.1.1.1/24
POS2/0/0
20.1.1.1/24
AS100
Configure OSPF on devices in AS 200 to ensure that routes to the address of Loopback0
on Router B are advertised to Router C.
Establish EBGP peer relationships between Router A and Router B, and between Router
A and Router C.
On Router A, configure a static route whose destination address is the address of Loopback0
on Router B and outbound interface is POS 1/0/0 on Router A.
On Router A, configure permanent advertisement of the static route to the address of
Loopback0 on Router B. In this manner, when POS 1/0/0 on Router A becomes faulty, the
static route to the address of Loopback0 on Router B still takes effect.
OSPF process IDs of Router B and Router C
Router IDs and AS numbers of all routers
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Loopback0
2.2.2.2/32
POS1/0/0
RouterB
40.1.1.2/24
POS2/0/0
30.1.1.1/24
LinkB
POS2/0/0
30.1.1.2/24
POS1/0/0
RouterC
20.1.1.2/24
AS20
0
2 IP Static Route Configuration
149