Checking The Configurations - Huawei Quidway NetEngine80E Configuration Manual

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
peer { ipv6-address | group-name } connect-interface interface-type interface-
number [ ipv6-source-address ]
The source interface and source address used to set up a TCP connection are specified.
Usually, BGP4+ uses the physical interface that is directly connected to the peer as the session
interface used for the TCP connection.
To increase the reliability and stability of the BGP4+ connections, configure the local interface
used for the BGP4+ connection as the loopback interface. In this way, when there are redundant
links on the network, the BGP4+ connections are not interrupted due to the failure of a certain
interface or a link.
----End

9.2.5 Checking the Configurations

After basic BGP4+ functions are configured, you can check BGP4+ peer information.
Prerequisites
Basic BGP4+ functions has been configured.
Procedure
l
l
----End
9.3 Configuring BGP4+ Route Attributes
BGP4+ has many route attributes. By configuring these attributes, you can change BGP4+
routing policies.
9.3.1 Before You Start
Before controlling BGP4+ route selection, familiarize yourself with the usage scenario, complete
the pre-configuration tasks, and obtain the required data. This can help you complete the
configuration task quickly and accurately.
Applicable Environment
You can change the BGP4+ routing policies by configuring the route attributes.
l
Issue 02 (2014-09-30)
NOTE
When establishing BGP4+ peer relationship between two devices through various links, specify the local
interface during the setup of a BGP4+ session on the devices by using the peer connect-interface command
is recommended.
Run the display bgp ipv6 peer ipv4-address verbose command to check information about
the BGP4+ peers.
Run the display bgp ipv6 peer ipv6-address { log-info | verbose } command to check
information about the BGP4+ peers.
BGP4+ priority
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 BGP4+ Configuration

1052