Configuring A 6Pe Peer - Huawei Quidway NetEngine80E Configuration Manual

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing

9.13.2 Configuring a 6PE Peer

IPv6 Provider Edge (6PE) interconnects separated IPv6 networks at different locations by using
the MPLS tunneling technology in an existing IPv4 network.
Context
Perform the following steps on the PE supporting the IPv4/IPv6 dual stacks:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
bgp { as-number-plain | as-number-dot }
The BGP view is displayed.
Step 3 Run:
peer ipv4-address as-number { as-number-plain | as-number-dot }
The IP address and AS number of a PE that needs to be configured with 6PE are specified.
Step 4 Run:
ipv6-family unicast
The BGP IPv6 unicast address family view is displayed.
Step 5 Run:
peer ipv4-address enable
A 6PE peer is configured in the IPv6 unicast address family view.
Step 6 Run:
peer ipv4-address label-route-capability
The capability of sending labeled routes is enabled.
----End
9.13.3 (Optional) Enabling 6PE Routes Sharing the Explicit Null
Label
By enabling IPv6 Provider Edge (6PE) routes sharing the explicit null label, you can save label
resources on 6PE devices.
Issue 02 (2014-09-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 BGP4+ Configuration
1104