Configuring Routers To Advertise A Default Route To A Peer - Huawei Quidway NetEngine80E Configuration Manual

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
bgp { as-number-plain | as-number-dot }
The BGP view is displayed.
Step 3 Run:
ipv6-family [ unicast ]
The BGP IPv6 unicast address family view is displayed.
Step 4 Run:
default-route imported
BGP4+ is configured to import the default routes.
If the default-route imported command is not used, you cannot import the default routes from
other protocols by using the import-route command.
Step 5 Run:
import-route protocol [ process-id ] [ med med | route-policy route-policy-name ]
BGP4+ is configured to import routes of other protocols.
Step 6 Run:
filter-policy { acl6-number | acl6-name acl6-name | ipv6-prefix ipv6-prefix-name }
export [ protocol [ process-id ] ]
Imported routes are filtered.
After BGP4+ filters the imported routes, only the eligible routes are added to the BGP4+ local
routing table and advertised to BGP4+ peers. If protocol [ process-id ] is specified, the routes
of the specific routing protocol are filtered. If protocol [ process-id ] is not specified, all the local
BGP routes to be advertised are filtered, including the imported routes and the local routes
advertised through the network command.
----End

9.4.5 Configuring Routers to Advertise a Default Route to a Peer

A router sends a default route with the local address being the next hop to the specified peer,
regardless of whether there are default routes in the local routing table.
Procedure
Step 1 Run:
system-view
Issue 02 (2014-09-30)
NOTE
Specify the process ID when the routes of a dynamic routing protocol are imported.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 BGP4+ Configuration
*
1064